ns am attaching the procedure from the manual. Allow us recognize if you have other questions. Also, below are part guides that will assist as well: https://www.altoalsimce.org/articles/replace-thermostathttps://www.altoalsimce.org/articles/how-an-engine-thermostat-works


You are watching: 2004 dodge dakota thermostat location v6

*

*

*

*

*

monitor the top rad hose ago to the engine. Wherein is end is the t-stat housing. The t-stat is under the housing.Let me recognize if you have other questions.Joe
when I start the van it operation fine, however when I put it in gear the engine overheats and all of my coolant leaks out of the overflow. Walk this typical my thermostat is bad?
Engine may overheat for numerous reasons. Start troubleshooting by ensuring coolant level is correct. If OK, eliminate thermostat and test for suitable operation. Come learn how to execute this, follow attach below..https://www.altoalsimce.org/articles/replace-thermostatThanks for utilizing altoalsimce.org!
How tough is the to change the thermostat. Does the alternator & ac compressor need to be removed. Any aid or direction would be substantially appreciated


See more: What Does It Mean Check Gages ? What Does Warning Light Check Gauge Mean

find the thermostat. This is located in a housing on the engine side of the top radiator water tap for all engines other than the 4.7L. On the 4.7L engine, the thermostat is located on the engine next of the reduced radiator hose. Disconnect the negative battery cable (both battery on diesels). Drainpipe the engine coolant indigenous the block until the level is below the thermostat. On V-10 engines, eliminate the support rod. On many V-6 and V-8 models, the alternator must be removed or repositioned for access to the thermostat housing. Eliminate the radiator water tap from the thermostat housing. Disconnect any type of sensors equipment to the thermostat housing. Remove the retaining bolts indigenous the thermostat housing. Keep in mind the lengths and also location of every bolt for ease that installation. Eliminate the thermostat housing, thermostat, and gasket, if fitted. Keep in mind the loved one positions of every components, especially gaskets and seals. Note the orientation the the thermostat in the housing. Come install: Be sure the brand-new thermostat is the correct one for your engine. On V-10 engines, keep in mind that over there is a rubber lip-type seal v a steel shoulder pressed right into the entry manifold in ~ the thermostat. The thermostat need to fit snugly in the seal. Clean the gasket or seal mating surfaces. File gaskets have to be replaced. Install the thermostat, gasket or seals. Install the thermostat housing on the engine. NOTEThe thermostat housing may have the indigenous FRONT on the (3.9L, 5.2L, 5.9L); this goes towards the front of the vehicle. Be sure all contents are properly seated before tightening. Tighten the housing bolts come 18 ft. Lbs. (24 Nm). Fasteners must be tightened evenly to avoid leaks or damage. Reinstall the radiator water tap onto the housing. NOTEEnsure that you have secured the system drainpipe plug(s) before refilling v coolant. Refill the radiator through a ideal coolant mixture. Connect the an unfavorable battery cable(s). Start the engine and bleed the cooling system. Ensure the the thermostat is operational (by check the upper radiator hose for warmth), and that there space no leaks.