Keep her Dodge Ram"s radiator cooling in ~ its finest by flushing it and adding new coolant. This article will guide you with the process.


This article applies to the Dodge lamb 1500 2nd and third Generation (1994-2008).

You are watching: Dodge ram radiator drain plug location

The radiator is draft to save the dodge Ram"s monstrous engine cool. The circulates coolant with the engine to ensure it remains cool under any type of driving condition. ~ a while, rust and also deposits start structure up within the radiator. Flushing the mechanism ensures it remains lubricated, rust free, and also without contaminants. It"s recommended you carry out a radiator flush as soon as a year to avoid the van from overheating. The procedure is simple and doing that yourself can save friend a good amount of money. Friend will require to drainpipe the radiator and also fill it with distilled water, then drain it again a couple of times more. It"s among the most underrated maintain you deserve to do for her truck, and also the benefit is remarkable.

*

Step 1 – remove radiator cap

Park top top a leveled ground, open the hood, and also remove the radiator cap. It"s located in the front of the auto on top of the radiator.

*
Figure 1. Make certain the truck is cool before opening the cap.
Warning

Before removed the radiator cap, be certain to put your hand on peak of the engine to examine if it is hot. If friend can"t touch the engine, the coolant within the engine is as well hot and also will burn you. Don"t ever before open it once the engine is hot.


Step 2 – drainpipe the old coolant

Locate the radiator"s drain valve on the bottom the the radiator. Girlfriend don"t have to raise the dodge Ram because it"s a high truck with sufficient room for this job. Place a tray under the drain plug. Then, making use of your wrench, loosen the drain valve. Permit it drain until it"s empty.

*
Figure 2. Loosen the radiator drain valve and drain the coolant.

Step 3 – fill radiator through distilled water

After girlfriend dispose the old coolant, nearby the drain plug and fill the radiator v distilled water. Once again, open up the drain valve and let the water drain out that the radiator. Repeat this procedure at least three times. Be sure to clock the water draining the end of the radiator. As soon as it becomes clean, clean water, you can move on come the following step.

*
Figure 3. Fill the radiator with distilled water and drain. Then repeat.

Step 4 – to fill radiator with new coolant

Tighten the drainpipe valve under the radiator. To fill the radiator with the new coolant. You can fill it till you watch the coolant within half an customs from the top.

*
Figure 4. To fill the new coolant up to half of an customs to one customs from the top.

See more: How Many People Does A Brisket Feed ? How Many People Can I Feed With One Brisket

Step 5 – start the engine

Keep the radiator lid off to bleed any air in the system. Start your truck and also let it heat up because that a minute or two. Clock the fluid. If it goes down, refill it come the very same level. Close the lid on the radiator, make sure it"s tight, and also put the hood down.