I"ve watched this trouble elsewhere, but I haven"t discovered a solution. I need to remove the lens from my fluorescent irradiate fixture so ns can adjust the bulbs. It shows up the only method to remove the lens would certainly be to remove one of the end caps top top the fixture therefore the lens can slide out. Yet I can"t view any means to eliminate the end caps. To eliminate them, it shows up the pressure that would certainly be forced may be great enough to rest them. I"ve never seen such a poor design for a an easy device. Ns could write-up photos if that would help.

You are watching: How to remove cover from fluorescent light fixture


*


Pic"s always help. Most times friend just have to flex the clean cover end one side, then it comes appropriate off.

The lens extends well into the end caps. There is no way sliding the lens either way and then flexing it would allow it to it is in removed.
Sometimes you acquire lucky and the whole frame w/lens lifts and can it is in jiggles loose. Otherwise, the is a video game if angles and also patience. Try to get one side together high as possible while pulling down on the other. Carry out this after the light has actually been on for a while therefore the plastic lens is a tiny warmer and also not as brittle. I"ve had actually success, I"ve likewise had to replace a couple that were much less than cooperative.
My guess: v is that one or both end caps snaps on and can be eliminated by tapping it close to the ceiling to pop it off the fixture. The lens would certainly then on slide out, providing you access to the tubes.
I"ll shot tapping one end cap off. So much I"ve just been trying come pry that off. As I mentioned, sliding the lens completely into either finish cap walk not allow the opposite end of the lens come come anywhere near dropping down.Added: goldstar wins! The plastic finish caps are organized to the fixture through two protruding tabs on every side that the end cap. Unfortunately, tapping easy on one end broke these plastic tabs off. Ns don"t care!I now see the correct method is to press really firmly in top top the finish of the steel fixture to deform the area so these tabs would then clear the steel fixture"s holes. V the finish cap off, the lens slides out.

See more: How To Fix A Badge Reel - How To Fix A Broken Retractable Badge Reel


Too negative you had actually to rest the tabs off one end cap to learn the trick, but, glad you acquired it resolved and thank you because that the feedback.
I set up a couple of brand-new 6000K daylight tubes and the area looks great now. So lot so, I desire to readjust the various other two still functioning tubes in a nearby fixture. Fortunately, its lens has actually a ridge on each side that just lifts up off the fixture. I"m an skilled now!
I love those. Ns forget what was in our laundry room once we bought this house, but I immediately replaced every little thing it was with two two-tube T-8 fixtures, one 4" and one 2", joined end-to-end, and also installed 6500K lamps (I think lock are) in them. That"s 120W the daylight right down the center of the room. If you don"t see a clues on the clean clothing in the room, you sure won"t see one somewhere else!Hey! go for it, expert!
*
*

altoalsimce.org®, established in 1995, is the leading independent home innovation and repair website. We welcome your comments and also suggestions. All information is provided "AS IS." Website operating problems call webmaster