Most cars these days seem specifically designed come hinder their owners from performing do-it-yourself maintain on them, also when it concerns the most basic of tasks. This is no the case, fortunately, when it comes to replacing the thermostat of the 2006 Chevy Impala. When it certainly not save the many comfortable engine compartment to job-related in--the muscle car of the mid-1960s will most likely forever organize that distinction--the "06 Impala nonetheless provides relatively easy accessibility to the thermostat.

You are watching: Where is the thermostat on a 2006 chevy impala


Open the hood the the Impala and locate the thermostat housing. Discover the biggest hose at the peak of her radiator, then follow it till it connects top top a section of the Impala"s engine block. The item that to which the water tap connects is the removable thermostat housing.


Use a jack to raise the Impala turn off the ground, then settle it under onto jack stands. Make certain the car is in park and the emergency brake is on.


Place a large container under the Impala"s radiator. Drain the radiator right into the bucket through loosening the clamp ~ above the reduced coolant hose through a flat-blade screwdriver, climate removing the hose totally so the the coolant flows right into the bucket. When the coolant stops flowing, collection the bucket aside.


Use the screwdriver to ease the clamp top top the coolant hose connecting to the thermostat housing, then eliminate the hose from the real estate completely. This will offer you accessibility to the bolts securing the real estate to the Impala"s engine block.


Use a wrench or ratchet and sockets to eliminate the bolts securing the real estate to the engine block, then collection them beside somewhere where you will certainly not shed them. Loosen and remove the thermostat housing to reveal the thermostat.


Make a careful note of how the thermostat is oriented towards the Impala"s engine block. You should install the new thermostat in the specific same method as the old one is installed. Remove and also discard the old thermostat.


Use a scraper tool or a razor tongue to remove any kind of remaining bits the thermostat gasket from the bottom that the thermostat housing and from the engine block. The is vital to obtain all the continues to be off; otherwise the brand-new gasket will certainly not seal properly.


Apply a layer of gasket sealant come the bottom that the Impala"s thermostat housing, then press the brand-new gasket against the sealant so the it sticks and also makes a great seal.


Install the brand-new thermostat in the manner you detailed in step 6, then replace the thermostat housing and secure it down through the bolts. Reconnect the hoses girlfriend disconnected--making sure that the clamps are tightened down so no coolant leaks--and refill the Impala"s radiator v the coolant friend drained the end earlier. Use your jack to reduced the Impala ago to the ground.

See more: 1990 Honda Accord Fuel Pump Location, Where Is Fuel Pump Located In A 1990 Honda Accord


Jack Jack stand Clean container Flat-blade driver Wrench or ratchet and also socket set Scraper tool Gasket sealant Thermostat gasket instead of thermostat
never attempt to go under a car if the is supported just by a jack. Work out the vehicle on jack stand first. Make sure the Impala"s engine is completely cool before attempting this procedure. Severe injury could result if you carry out not take this precaution.

Joshua Benjamin began as a experienced freelance writer in 2009. The has properly published numerous articles spanning a broad variety of topics. Benjamin's areas of expertise encompass auto repair, computer hardware and also software, firearms operation and maintenance, and home repair and also maintenance. The is currently pursuing a Bachelor of Business administration from California State University, Fresno.